• Manual tube benders Tools For bending stainless steel and copper tubing from 1/4″ to 1/2″ and 6 mm to 16 mm outside diameter
• FITOK Hand Tube Benders is used for tube bending and provides high quality performance in tube bending solutions
• Roll dies reduce bending force and tube ovality, as compared to conventional slide block design, used two roller design
• 1° to 180° bending range for one bending tools
• Available for Fractional and Metric size, and depend of radius request
• Tubing Restrictions when  used manual tube benders:
       Note :
       The hand tube bender can not be used for SAF 2507 tubing over 1/4″ or for medium-pressure tubing.
       Tubing should be free of scratches and appropriate for bending.

      Fractional Tubes
 High-quality, cold-drawn, seamless carbon steel hydraulic tubing ASTM A179 or equivalent, with hardness equal to or less than 72 HRB (130 HV).
 High-quality, seamless and austenitic stainless steel tubing ASTM A269/A213 (304, 316, etc.) or equivalent, with hard (200 HV or less). ness  90  HRB
      Metric Tubes
 High quality, cold drawn, carbon steel hydraulic tubing DIN 2391 or equivalent, with hardness equal to or less than (72 HBR)130 HV.
 High quality, seamless and welded Austenitic stainless steel tubing EN ISO 1127 (304, 316, etc.) or equivalent, with hardness equal to or less than (90 HRB)200 HV.

 Please read our tools guide for FITOK manual tube bender and how to cutting tube, and Deburring Tools.